Chris has a Master’s degree in engineering and uses his knowledge to write about a variety of topics from an analytical perspective.

Cooking food over a hot open flame is one of my favorite summer-time activities. Although I prefer the flavor of a charcoal grill, nothing can beat the convenience and control of grilling with propane. Whether it’s a perfectly-seared tuna or a flawlessly-cooked steak, a propane grill can give you the precise control necessary to properly prepare your food.

Reading: How much is a propane tank for a grill

However, there are a few downsides to this method of grilling. Besides having a diminished flavor, propane tanks tend to run out of fuel at the worst possible moments. To fix this problem, I initially bought a propane tank gauge. I had hoped that it would tell me when the tank was getting low so that I could go get a refill just before it ran out.

Unfortunately, this did not work too well for me. The gauges that I tried were either highly inaccurate or actually reduced the amount of gas flowing to the burners. After scratching my head for a moment, I thought to myself, “Wouldn’t it be nice to know how long the tank would last under normal cooking conditions?” If I knew this information, I could calculate how many meals I could prepare before my grill ran out of fuel. So that’s exactly what I did.

In this article, I will show you a formula that you can use to determine how long your propane tank will last under normal cooking conditions.

Table of Contents

## The Formula for Calculating How Much Propane Is Left in Your Tank

## Formula Derivation

**T**= the grilling time**P**=the amount of propane you have**H**= the heating value of the propane**B**= the maximum heat output of your grill**k**= efficiency factor, meaning what percent “power” you’re cooking with

Deriving this formula is rather simple.

First, multiply the amount of propane you have by its heating value: PH.

Next, divide that by your grill’s maximum heat output to get the minimum grilling time: Tmin = PH/B.

However, most people don’t cook at the maximum grill setting for an extended period of time. In fact, propane usage during typical cooking conditions is normally around 50-75% of the maximum heat output. If you cook with all the burners set on medium, your output would be around 75% of the maximum. If you use fewer burners, your actual output will also change. This is where I introduce an efficiency factor, ‘k,’ to adjust the time calculation for this variation.

With the introduction of the ‘k’ factor, the final formula becomes the picture that you see above.

## How to Determine the ‘k’ Factor

Read more: how to keep grill grates from rusting | Family Cuisine

The ‘k’ factor effectively reduces your grill’s total output in the computation. Use the chart below to determine the ‘k’ value for your typical grilling scheme. The derivation of the various ‘k’ factors is beyond the scope of this article.

Once you select a ‘k’ factor based on your typical grill’s usage, you can compute the total estimated grilling time (T). Divide this time by the average time it takes to cook a meal to estimate the number of meals you can grill. Now all you have to do is keep track of how many times you use the grill to know how much fuel you have left.

For example, if you have a six-burner grill and only cook with one burner on the lowest setting, you are effectively generating only 10% (0.10) of the maximum heat output of that grill. However, if you crank that same burner to its maximum setting, you will only be generating about 17% of the maximum heat that could be generated by the grill.

## What If I Want to Calculate How Much Propane Is Left in a Partially Full Tank?

Let’s say that you want to know how much propane you have left in the tank connected to your grill, and you don’t have a pressure gauge with you. What do you do? It’s simple actually: all you need to do is weigh the propane tank, and then subtract the Tare Weight (marked as a number following “TW” on the top of the tank) from the weight shown on the scale. A standard barbecue propane tank can hold 20lbs of propane. Even if you have one or two pounds of fuel left, that can be enough to prepare just one more meal.

## Example Problem With Step-By-Step Explanation

John just bought a new propane tank (15lbs of propane) and wants to know how long this will last him. John’s grill has a maximum heat output of 30,000 BTU with three burners. A typical meal takes John 30 minutes to complete using medium heat.

**Step 1: Define the Variables:**

Amount of Propane: P = 15 lbs

Heating Value of Propane: H = 21,600 BTU/LB

Maximum Heat Output of Grill: B = 30,000 BTU/hr

‘k’ Factor: 0.74 (All Burners, Medium Heat)

Read more: When Should You Clean A Pellet Grill? (This is Important)

**Step 2: Solve for Propane Usage Time:**

T = ((15lbs)(21600 BTU/LB))/((0.74)(30,000 BTU/hr)) = 14.6 Hours

**Step 3: Now compute how many meals John can make with his grilling arrangement:**

Meals = 14.6 hrs / 0.5 hrs = 29.18 meals. Therefore, John could cook once a day for a month or about once per week for 7 months.

## Two Additional Factors Potentially Affecting Your Calculations

**The Average Heating Value of Propane:**Propane is a very lightweight hydrocarbon with a chemical formula of C3H8. It is a by-product of the crude oil and natural gas refining processes. At room temperature, propane is a gas. The gas is compressed into a liquid and stored in variously-sized steel containers. Propane has a heating value between 91,200 and 92,000 BTU per gallon (depending on your source). A heating value of 91,600 BTU/gal (21,600 BTU/lb) is the commonly accepted value presented by the American Gas Association. Since it is also the midpoint of the range of values found in my research, this is the number you should use to calculate your propane usage time.**The Size and Type of Grill You Have:**Your estimated total cooking time for a single propane tank will also depend on the type and size of grill that you have. There are literally hundreds of types and configurations of propane grills that you can choose from. All grills should have a maximum heating value reported in their manual. If you don’t have the manual, you can estimate that each burner produces about 10,000 BTU/hr of heat. A typical grill might have a maximum total heat output of 20,000-40,000 BTU/Hour (two to four burners). Some small grills may only produce 10,000 BTU/hour (one burner), while larger ones may have an output of 80,000 BTU/Hour (eight burners).

## How Else Can I Check My Propane Levels?

While these aren’t the most accurate ways to test your levels, these alternatives might come in handy at some point.

**Pour Water on It:**Grab a glass of water, and pour the water down the side of the tank. Use your hand to find the spot where the tank goes from feeling warm to feeling cool. The line where it begins to feel cool is about how much propane you have left.**Weigh It**: You’ll need a scale for this one. The average empty propane tank for grilling weighs about 17 pounds and can hold about 20 pounds of gas. Current tank weight – base weight = how much propane is left. So, if you weigh a container that you know is 15 pounds when empty and it weighs 20 pounds currently, you know you have 5 pounds of gas left.**Buy a Gauge**: While this is an option, I don’t recommend it. As I said earlier, I found that my tank went through more gas while using this. And the readings weren’t that accurate anyway.

## Should I Refill or Exchange My Propane Tank?

Refill it.

This is a common question these days. If you want convenience (and you’ll pay for it), then go for a tank exchange. Some retailers even have automated machines that can exchange a tank for you without even having to interact with an employee.

However, if you want to save lots of money, always have your tank refilled. Not only will you pay less per pound of propane, but you also won’t lose what’s left in the tank when you exchange it. Also, if you get your tanks refilled, you will often actually get more propane than if you just exchanged the tank. Many tank exchanges don’t even give you a completely full tank (which would contain 20lbs of propane) but instead leave the tank filled to 15-18lbs. Most people never check, and don’t even realize that they aren’t getting a full tank!

## Questions & Answers

**Question:** What is the lifespan of a 5 lb propane tank?

**Answer:** A standard 5lb propane tank can potentially last 50 or more years with proper care and use. Typically, these types of tanks should be check for damage, leaks, etc. and re-certified for use 12 years after the date of manufacture and then every five years after that. Some sources recommend testing and inspection every ten years instead.

**© 2011 Christopher Wanamaker**

Read more: Marinated Smoky Bacon-Wrapped Shrimp Skewers

For more information please see the list of **How much is a propane tank for a grill**

**Source:** https://delishably.com/cooking-equipment/Calculating-How-Long-Your-BBQ-Propane-Tank-Will-Last